30
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Glass Door Cleaning and Maintenance
Cleaning:
Do not remove or clean the glass door when hot. When cool,
the glass may be cleaned with a clean, soft cloth and a household glass
cleaner. For cleaning white condensation from the interior glass, use
a gas fireplace glass cleaner available from your dealer. Use of caustic
or abrasive cleaners may damage the glass. DO NOT spray commercial
glass cleaner with ammonia on the door and glass gasket as it may dis-
solve the gasket glue.
Electrical Requirements:
This appliance is equipped with an electronic valve and electronic pilot
ignition system (which can be switched from Intermittent to standing
pilot mode - see
Page 23)
. External electrical 120 Volt power is required
to operate the blower system of this appliance and recommended to oper-
ate the burner system. This appliance is equipped with a battery backup
system in case of a power outage (see
Battery Backup
on
Page 21
for
more information).
This appliance, when installed, must be electrically grounded in accordance
with local codes, or in the absence of local codes, the National Electrical
Code ANSI/NFPA 70-latest edition, or the Canadian Electrical Code, Part 1,
CSA C22.1-latest edition. (See Operating Options for burner ON/OFF switch
information).
Figure 31 - Blower Assembly Removal
Blower
Assembly
Fireplace
Insert Back
Repair:
If the glass is broken in the glass door, the entire door (metal
frame, gasket and glass) should be replaced as a unit. This replacement
glass door is available from your IHP dealer. Do not use substitute parts
or materials. The glass is neo-ceramic and alternative types must not
be used.
NOTE: BE CAREFUL NOT TO SPRAY COMMERCIAL GLASS
CLEANER WITH AMMONIA ON GASKET AREA OF DOOR. AM-
MONIA WILL DISSOLVE GASKET GLUE.
Fuel Conversion
Converting this appliance between natural gas and propane (LP) can be
accomplished by installing a gas conversion kit. Only a qualified service
technician should perform the conversion.
Gas Conversion Kits: Please see instructions provided with
conversion kit.
Blower Removal
Unplug the power supply cord from the electrical outlet prior to removing
the blower. The blower can be accessed on the back of the insert.
1. Remove the insert from the fireplace.
2. Remove five phillips screws holding fan assembly in place and care-
fully move assembly out of the way, exposing appliance wiring
(see
Figure 31)
.
3. Disconnect the fan wiring from the appliance.
To re-install the blower, repeat these steps in reverse order.
WARNING
•
DO NOT use abrasive cleaners on glass.
•
DO NOT clean glass when hot.
