Copyright 2021 Iron Bow Technologies
15
Getting Started
Powering On and Off
The Poly CLINiC control panel, display, camera and codec will automatically power on
when connected to AC power.
The integrated Poly codec has a “Touch” sensor power switch that can be used to power
the codec on and off individually from the rest of CLINiC components, although that is
typically not necessary.
The codec “Touch” sensor power switch is located behind the display on the top of
the codec enclosure, as shown in the figure .6. below
Powering On the CLINiC
Connect the peripherals to the HDMI and/or VGA ports of the CLINiC before connecting
the CLINiC to AC power.
To power on the CLINiC:
Connect the CLINiC to AC power. This will automatically power on the codec,
camera, display and control unit of the CLINiC. A splash screen is displayed
within several seconds.
NOTE:
If the display goes to power-saving mode and a splash screen is not displayed,
you will need to separately power on the codec. This could happen because the codec was
previously powered off using the power sensor. Whenever you power off the codec using
the power sensor, you will need to touch the power sensor to restart it.
Figure 5. Poly CLINiC
“Touch” Sensor Power
Switch Location
Power Indicator “Touch” Sensor Power Switch
Summary of Contents for CLINiC-P-12X27-B02
Page 27: ...Page intentionally left blank ...
