eZ-Analyst
889691
Edit Menu 4-15
Negative Averaging
Edit Menu
> Configuration >
Input Channels Tab
The Input Channels tab
displays the current setup conditions of the 8 Analog Input Channels
(CH1 through CH8) and the 4 Tachometer Channels (T1, T2, T3, and T4) on a channel-by-
channel basis. It also provides a means of changing the input channel settings. These
changes are accepted as soon as the <Apply> or <OK> button is clicked.
Note
: Output channel configuration is discussed on page 4-15.
When using WaveBook hardware,
eZ-Analyst
supports up to 64 channels
of input. If your WaveBook’s hardware configuration has more than 64
channels,
eZ-Analyst
will display an error message and enter the Playback
mode. If you wish to use Measurement mode you will have to reduce the
channel count by removing expansion modules.
To remove the expansion
modules you must
physically disconnect them from the WaveBook system
.
When using ZonicBook/618E hardware,
eZ-Analyst
supports up to 56
channels of input. If your ZonicBook/618E hardware configuration has
more than 56 channels,
eZ-Analyst
will display an error message and
enter the Playback mode. If you wish to run in the Measurement mode
you will have to reduce the channel count by removing expansion modules
by
physically disconnecting them from the ZonicBook/618E system
.
If any ZonicBook Tach channel is set for Period Mode measurements, all
ZonicBook Tach channels may be out of phase in relation to the ZonicBook
Dynamic channels. If additional in-phase Tach channels are needed, you
must use Dynamic channels configured as Tach channels.
