I-O 2677e Ethernet Display User s Guide
Printer Operation
8
10/100 Base T
The RJ45 connector is where the Ethernet cable is attached for network
connectivity. The 2677e will automatically link at the speed of the network.
DB-15 Connector
The DB-15 connector is used for connecting your LCD Display. The 2677e
Outputs VGA with Resolution up to 1600 x 1200 High Colors and supports
80-132 column full screen.
USB
The USB 2.0 connector on the back is used for a keyboard, mouse or printer.
Installation
No special training is needed to install the I-O 2677e. Simply follow the steps outlined under Hardware
Installation, then configure the display station and the AS/400.
Hardware Installation
1. Inspect the package for damage.
2. Connect the monitor
3. Connect the keyboard
4. Connect the Ethernet cable
5. Connect the printer (optional)
6. Connect the power supply and power up the monitor.
Configure the 2677e Ethernet Display
The 2677e can be configured locally, using the on-screen setup process, or remotely using the I-O
Configuration Utility found on the Utility CD. (The I-O Configuration Utility is not required to configure
the 2677e, but must be used whenever a firmware update is to be applied.) Both methods are
described in the following pages.
Configuring the 2677e using Local Setup with the Connection Manager
1. After applying power, the 2677e will go through a Windows CE boot process and display a
Connection Manager window. If the
Connection Manager window doesn’t show, click on Start,
Programs, and Connection Manager.
By default, the 2677e is set with Dhcp enabled, so the unit will connect to the network through a
Dhcp assigned address. If you do not have a Dhcp server, or the unit does not pick up an address,
you can manually assign a static IP address by going into the Network Setup.
a. From the Connection Manager screen, press F2 to open the Control Panel.
b. Select Network and Dial-up Connections.
c. Double click on the PCI-R60401 connection and select Specify an IP address.
d. Enter a static IP Address, Subnet Mask, and Default Gateway. OK and close the Control Panel.
