INVT GD10-0R2G-2-B, Operation Manual

Page: 8 / 125

Goodrive10 Series Mini VFD Safety precautions
-3-

Ensure to avoid physical shock or vibration during delivery and installation.

Do not carry the VFD by its cover. The cover may fall off.

Install away from children and other public places.

The pick-up current of the VFD may be above 3.5mA during operation. Ground with
proper techniques and ensure the grounding resistor is less than
10Ω. The conductivity of
PE grounding conductor is the same as that of the phase conductor (with the same cross
sectional area).

R, S and T are the input terminals of the power supply, while U, V and W are the motor
terminals. Please connect the input power cables and motor cables with proper
techniques; otherwise the damage to the VFD may occur.
1.3.2 Commissioning and running

Disconnect all power supplies applied to the VFD before the terminal
wiring and wait for at least the designated time after disconnecting the
power supply.

High voltage is present inside the VFD during running. Do not carry out
any operation except for the keypad setting.

The VFD may start up by itself when P01.21=1. Do not get close to the
VFD and motor.

The VFD
can not be used as “Emergency-stop device”.

The VFD can not be used to break the motor suddenly. A mechanical
braking device should be provided.
Note:

Do not switch on/off the input power supply of the VFD frequently.

For VFDs that have been stored for a long time, check and fix the capacitance and try to
run it again before utilization (see Maintenance and Hardware Fault Diagnose).

Cover the front board before running, otherwise electric shock may occur.
1.3.3 Maintenance and replacement of components

Only qualified electricians are allowed to perform the maintenance,
inspection, and components replacement of the VFD.

Disconnect all power supplies to the VFD before the terminal wiring.
Wait for at least the time designated on the VFD after disconnection.

Take measures to avoid screws, cables and other conductive matters to
fall into the VFD during maintenance and component replacement.