BALNAFETTACH HOUSE, PH26 3LW (01479) 872 518 [email protected]
Below is brief overview of each of the settings:
Continuous Mode
Selects a duration for which the MicroFogger will stay activated after the trigger is pressed.
When in this mode, the continuous operation can be cancelled by pressing trigger again.
Usually limited to 10s but with time limits off, this is extended to 60s
Delay Mode
Selects the duration for which the MicroFogger will wait until continuous mode is activated.
Requires continuous mode to be on in order to work.
Limited to 300s
Loop Mode
Selects the number of operational loops that the MicroFogger will perform.
Requires Continuous and Delay mode to be turned
“
on
”
.
Usually limited to 5 but with time limits off, this is extended to infinite loops.
RC Channel
Allows you to adjust the Remote Control channel configuration.
By default, all 4 Remote Control buttons are available pre-programmed for use for various
set power levels but once a specific letter is selected, the MicroFogger will only be triggered
when that button is pressed on the remote.
This allows for up to 4 independently controlled MicroFoggers.
RC Program
Allows you to bind the MicroFogger to any 433mhz frequency remote control.
Simply press
“
Select
”
button and follow the on-screen instructions.
If your Remote Control has less than 4 buttons, you can re-press the same buttons again to
complete the process.
Remote ON/OFF
Allows you to turn
“
off
”
the MicroFogger’s remote control functionality to avoid
unintentional activation during important performances.
Time Limit ON/OFF
Toggles whether the time limit is
“
on
”
or
“
off
”
.
When it is
“
off
”
, the MicroFogger will not turn off after 10 seconds of continuous operation.
It will also unlock greater values in the continuous and loop mode menus.
This is an advanced feature and can be an issue if used improperly.
We recommend keeping it
“
off
”
at all times.
