4. Character display information
Pano360 is equipped with character, segment display (
Fig 1.-
M
) that feeds back useful
information regarding the device. Bellow is a complete list of all the characters and the
functions/malfunctions they indicate.
Symbol
Description
Numbers from 0 to 9 indicate the preset which is currently chosen. You can move
through different presets by pressing the button on the side of Pano360
(
Fig 1.-
N
) or by triggering a digital channel on your receiver (make sure the 3
rd
digital input is connected with the RC receiver (
Fig. 6
).
Letter C (
C
urrent) – the current value has exceeded the Threshold and did not
drop below the Threshold minus Hysteresis within the Time Limit (
3.2.2
/
Fig.17
)
– as a result the motor has been turned off. This usually happens when the drive
is blocked. Please make sure there is nothing in the way of the camera, check if
the drive (pulleys, belt) is not blocked. This message can be also displayed if a
heavy camera is used with aggressive acceleration, max. speed and deceleration
parameters. If you are using a high payload make sure to adjust the overcurrent
protection or lower the Acceleration, Deceleration and Max Speed Values (Fig.
11-E) to enable slower camera movement.
Letter L (boot
L
oader) – the bootloader is active. The device is updating the
firmware.
Letter A – stop detection is in progress, the controller is waiting until the current
value drops below the threshold and will remain below thr hysteresis for
the specified time (
3.2.3
/
Fig. 19
) .
Letter H or U letter – internal error, should you see this symbols make sure to
write down what has happened before this message occurred. Contact us and
provide a short description of the occurrence:
contact
@invendyne.com
Letter P (
P
ower) – there is a problem with the motor power supply, the voltage is
not within the desired range. This can happen due to a variety of reasons, for
example: the battery voltage is too low, there is a short circuit, the power
converter is damaged etc.
Left, bottom corner – autofocus is active (
Fig. 20
).
Right, top corner – shutter is active (
Fig.
20
).
Tab. 4
A complete list of the character display messages.
