Excelerator XLT Series
32
Part No. 1114850
FORE/AFT SEAT
ADJUSTMENT (FIGURE 5)
ANGLE
NOTE: Seat should be adjusted so that when
seated with feet in the footrests, there is a slight
bend at the knee and a slight bend at the elbow
when the hand crank is furthest away.
1. If installed, activate parking brake.
2. Loosen, but do not remove the four
(4) rear socket screws that secure the
rear seat frame to the handcycle
frame.
3. Loosen, but do not remove the two
(2) front socket screws that secure the
front of the seat frame to the
handcycle frame.
NOTE: There are socket screws on the right
and left side of the handcycle.
4. Loosen, but do not remove the hex
bolts and locknuts that secure the two
(2) seat angle adjustment clamps to the
rear seat supports.
NOTE: There is one (1) clamp on the right and
left side of the handcycle.
5. Perform one (1) of the following:
A.
MOVING THE SEAT
REARWARD
- While lifting up
on the back support tubes, push
the seat rearward to the desired
position.
B.
MOVING THE SEAT
FORWARD
- While pushing
down on the back support tubes,
pull the seat forward to the desired
position.
6. Tighten the six (6) socket screws that
secure the seat frame to the handcycle
frame securely.
7. Tighten the hex bolts and locknuts that
secure the two (2) seat angle
adjustment clamps to the rear seat
SECTION 5
RIDING
POSITION
RIDING POSITION
FIGURE 5 - FORE/AFT SEAT
ADJUSTMENT
Front Socket
Screw
Rear Socket
Screws
Handcycle
Frame
Seat
Frame
Seat Angle
Adjustment
Clamps
Height
Adjustment
Bracket
Height Adjustment
Clamp
Back Support
Tube
All manuals and user guides at all-guides.com