Part No. 1114850
29
Excelerator XLT Series
SECTION 5
RIDING
POSITION
RIDING POSITION
4. Tighten the hex nut to secure the hand
crank in the desired position.
5. Tighten the two set screws on the
lower clamp.
6. Tighten the chain if necessary. Refer to
SECTION 7 of this manual.
FOOTREST AND LEG GUARD REPLACEMENT
(FIGURE 2)
FOOTREST
1. Note the position of the existing
footrest.
2. Remove the hex bolt and locknut that
secure the existing footrest to the
fork.
3. Remove the existing footrest from the
clamp on the fork.
4. Slide the new footrest into the clamp
on the fork to the position noted in
STEP 1.
5. Reinstall the hex bolt and locknut.
Tighten securely.
6. Repeat STEPS 1-5 for the opposite
footrest, if necessary.
LEG GUARD
1. Loosen the two (2) allen screws on
each mounting clamp.
2. Position each mounting clamp onto the
fork under the brake cable as shown in
FIGURE 2.
NOTE: The leg guard should surround, but not
touch, the REAR of the front tire.
3. Tighten the two (2) allen screws on
each mounting clamp securely.
Lower
Clamp
Set Screws
Chain
Fork
Stem
Hex
Nut
Upper Clamp
FIGURE 2 - HAND CRANK
HEIGHT - EXCELERATOR XLT
GOLD
Brake
Cable
LEG GUARD REPLACEMENT
FIGURE 2 - FOOTREST AND LEG
GUARD REPLACEMENT
Mounting Clamp
Fork
Allen
Screws
Rear of
Front Tire
Leg Guard
FOOTREST REPLACEMENT
Clamp, Hex
Bolt and
Locknut
Footrest
Fork
All manuals and user guides at all-guides.com