SECTION 11—CONTROLLER
Zoom 300 and Zoom 400
76
Part No 1122167
Replacing/Resetting the Circuit Breaker
Replacing
NOTE: For this procedure, refer to FIGURE 11.5, FIGURE 12.2, and FIGURE 12.3.
1. Turn power OFF and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat on page 19.
3. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
4. Perform one (1) of the following:
• On Zoom 300 - Disconnect the controller from the batteries by pulling the RED and
BLACK controller connector from the RED and BLACK battery connector. Refer to
FIGURE 12.2.
• On Zoom 400 - Disconnect the controller from the batteries by pulling the two (2)
BLACK battery connectors from the BLACK wiring harness connectors. Refer to
FIGURE 12.3.
5. Remove the YELLOW metal connectors of the wiring harness from the circuit breaker.
6. Remove the two (2) locknuts that secure the circuit breaker to the controller tray.
7. Remove the circuit breaker.
8. Position the new circuit breaker so that it passes through the mounting hole on the
controller tray.
9. Position the locknuts on the end of the circuit breaker and securely tighten.
10. Connect the YELLOW metal connectors from the wiring harness to the metal
connectors of the circuit breaker.
11. Perform one (1) of the following:
• On Zoom 300 - Connect the controller from the batteries by pulling the RED and
BLACK controller connector from the RED and BLACK battery connector. Refer to
FIGURE 12.2.
• On Zoom 400 - Connect the controller from the batteries by pulling the two (2)
BLACK battery connectors from the BLACK wiring harness connectors. Refer to
FIGURE 12.3.
12. Install the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
13. Install the seat. Refer to Removing/Installing the Seat on page 19.
