SECTION 6—ARMS
Compass™XE
and Allegro®
56
Part No 1127114
Adjusting the T-Arms
Height
NOTE:
For
this
procedure,
refer
to
FIGURE 6.14.
1. Unlock
the
T
‐
arm
by
flipping
the
T
‐
arm
release
lever
towards
the
inside
of
the
wheelchair.
NOTE:
If
necessary,
pull
out
on
the
T
‐
arm
release
lever
and
rotate
180°
so
it
can
be
flipped
towards
the
outside
of
the
wheelchair.
2. Slide
the
T
‐
arm
to
desired
height:
• Low
Height
T
‐
arms
‐
Nine
positions.
• High
Height
T
‐
arms
‐
Seven
positions.
NOTE:
If
the
inside
T
‐
arm
post
does
not
slide
up
and
down
in
the
outside
T
‐
arm
post
as
desired,
perform
one
of
the
following:
• Tighten
‐
Tightening
the
set
screws
on
the
outside
T
‐
arm
post
will
make
it
harder
to
move
the
inside
T
‐
arm
post
up
and
down.
• Loosen
‐
Loosening
the
set
screws
on
the
outside
T
‐
arm
post
will
make
it
easier
to
move
the
inside
T
‐
arm
post
up
and
down.
3. Lock
the
T
‐
arm
by
flipping
the
T
‐
arm
release
lever
towards
the
front
of
the
wheelchair.
FIGURE 6.14
Adjusting the T-Arms -
Height
Width
NOTE:
For
this
procedure,
refer
to
FIGURE 6.15.
1. Remove
the
two
mounting
screws
that
secure
the
arm
pad
to
the
arm
tube.
2. Turn
the
arm
pad
around
and
reposition
the
arm
pad
on
the
arm
tube.
3. Secure
the
arm
pad
to
the
arm
tube
with
the
two
mounting
screws.
4. Repeat
STEPS
1
‐
3
for
the
opposite
side,
if
necessary.
FIGURE 6.15
Adjusting the T-Arms -
Width
Set Screws
Outside
T-Arm
Post
Arm Post
Inside T-Arm
Arm Post
T-Arm Release Lever
- Unlocked Position
Arm
Pad
Mounting
Screw
Arm Tube
Mounting
Screw
