SECTION 6—ARMS
Part No 1127114
47
Compass™XE
and Allegro®
FIGURE 6.3
Repositioning Conventional Arms - Repositioning Rear Arm Sockets
Repositioning Front Arm Sockets
NOTE:
For
this
procedure,
refer
to
FIGURE 6.4.
1. Determine
the
necessary
front
arm
socket
position
for
the
necessary
seat
depth.
Refer
to
Changing
Seat
Depth
on
page 86.
2. Remove
locknut
and
screw
that
secure
the
front
arm
socket
to
the
wheelchair.
3. Move
the
front
arm
socket
to
the
position
determined
in
STEP
1.
4. Resecure
the
front
arm
socket
to
the
wheelchair
with
the
screw
and
locknut.
5. Repeat
STEPS
1
‐
4
for
the
opposite
side
of
the
wheelchair.
FIGURE 6.4
Repositioning Conventional
Arms - Repositioning Front Arm Sockets
Using/Installing/Adjusting Cantilever Arms
NOTE:
The
cantilever
arms
are
designed
for
use
with
the
fixed
height
back
canes
only.
Using Locking Cantilever Arms
NOTE:
For
this
procedure,
refer
to
FIGURE 6.5
on
page
48.
1. Push
the
locking
mechanism
actuator
towards
the
front
of
the
wheelchair.
2. While
holding
the
locking
mechanism
actuator,
pull
up
on
the
cantilever
arm
towards
the
rear
of
the
wheelchair.
3. If
necessary,
the
locking
mechanism
in
the
cantilever
arm
can
be
repositioned
so
the
cantilever
arm
will
open
down
instead
of
up.
Refer
to
Adjusting
Cantilever
Arm
Pad
Depth/Replacing
Cantilever
Arm
Pad
on
page 54.
4. To
lock
the
cantilever
arm,
push
down
until
there
is
an
audible
click.
5. Pull
up
on
the
cantilever
arm
to
make
sure
it
is
locked
in
place.
Locknut
Coved Spacer
Wheelchair Frame
Rear Arm Socket Mount
Nylon Shim
Rear Arm Socket
Hex Bolt
Locknut
Wheelchair
Frame
Hex Bolt
Front Arm
Socket
