SECTION 5—FRONT RIGGINGS
Part No 1127114
41
Compass™XE
and Allegro®
Installing/Removing Elevating Legrests
NOTE:
For
this
procedure,
refer
to
FIGURE 5.8
and
FIGURE 5.1
on
page
35.
Installing
1. Place
elevating
legrest
on
the
outside
of
the
wheelchair
and
insert
mounting
pin
into
the
mounting
tube.
2. Rotate
elevating
legrest
toward
the
inside
of
the
wheelchair
until
it
locks
in
place.
NOTE:
The
calfpad
of
the
legrest
will
be
on
the
inside
of
the
wheelchair
when
locked
in
place.
3. Repeat
STEPS
1
‐
3
for
the
other
elevating
legrest
assembly.
Removing
1. Push
the
legrest
release
handle
inward
while
rotating
the
elevating
legrest
outward.
2. Lift
the
legrest
assembly
out
of
the
mounting
tube
of
the
wheelchair
frame.
3. Repeat
STEPS
1
‐
2
for
opposite
side,
if
necessary.
FIGURE 5.8
Replacing Sector Block
Raising/Lowering the Elevating Legrest
NOTE:
For
this
procedure,
refer
to
FIGURE 5.9.
1. Perform
one
of
the
following:
• Raising:
Lift
legrest
assembly
up
to
desired
height.
• Lowering:
Lift
elevating
legrest
assembly
up
with
one
hand.
While
supporting
the
eleveting
legrest
assembly
(and
user’s
leg),
pull
release
lever
up
with
other
hand
and
lower
legrest
assembly
to
desired
height.
FIGURE 5.9
Raising/Lowering the Elevating
Legrest
Release Handle
NOTE:
The
mounting
tube
will
be
part
of
the
seat
frame
or
wheelchair
front
frame
depending
on
wheelchair
model.
Mounting Pin
Mounting
Tube
Elevating
Legrest
Inside of
Wheelchair
Release Lever
Elevating Legrest
Assembly
