SECTION 6—ARMS
Compass™XE
and Allegro®
58
Part No 1127114
NOTE:
Make
sure
the
hex
bolts
are
torqued
to
156
inch
pounds,
otherwise
the
T
‐
arm
sockets
will
be
capable
of
rotating
around
the
wheelchair
frame.
NOTE:
If
desired,
locking
pins
can
be
installed
to
secure
the
T
‐
arm
brackets
to
the
wheelchair
frame,
as
shown
in
FIGURE 6.17.
6. Repeat
STEPS
2
‐
6
for
the
opposite
side
of
the
wheelchair.
7. Install
the
T
‐
arms
into
the
T
‐
arm
sockets,
refer
to
Installing/Removing
T
‐
Arms
on
page 55.
8. Reinstall
the
rear
wheels
from
the
wheelchair.
If
necessary.
Refer
to
Removing/Installing
Rear
Wheels
on
page 101.
FIGURE 6.17
Installing the T-Arm Sockets
Adjusting T-Arm Sockets
NOTE:
For
this
procedure,
refer
to
FIGURE 6.18
on
page
59.
1. Remove
the
rear
wheels
from
the
wheelchair.
2. Remove
the
three
hex
screws
and
washers
that
secure
the
T
‐
arm
socket
and
T
‐
arm
clamp
to
the
wheelchair
frame
and
remove
the
T
‐
arm
socket
from
the
wheelchair.
3. If
equipped
with
optional
locking
pins,
remove
the
locking
pins
that
secure
the
T
‐
arm
socket
to
the
wheelchair
frame.
4. Loosen,
but
DO
NOT
remove
the
four
hex
screws
and
washers
that
secure
the
T
‐
arm
socket
together.
NOTE:
The
T
‐
arm
socket
will
disassemble
if
the
four
hex
screws
and
washers
are
removed.
5. Slide
the
T
‐
arm
into
the
T
‐
arm
socket
until
the
lock
lever
is
in
the
slot
in
the
T
‐
arm
socket
and
an
audible
“click”
is
heard.
6. Squeeze
the
T
‐
arm
socket
together
until
the
socket
is
flush
with
the
T
‐
arm.
7. While
holding
the
T
‐
arm
socket
together,
tighten
the
four
hex
screws
and
washers
securely.
8. Press
in
on
the
locking
lever
and
lift
the
T
‐
arm
straight
up
and
out
of
the
T
‐
arm
socket.
9. Repeat
STEPS
5
‐
7,
if
necessary
until
the
T
‐
arm
slides
in
the
T
‐
arm
socket
as
desired.
10. Reinstall
the
T
‐
arm
socket
onto
the
wheelchair.
Refer
to
Installing
the
T
‐
Arm
Sockets
on
page 57.
Outside
Middle
Outside
Hex Screw
Washers
T-Arm Clamp
Wheelchair
Frame
Optional Locking Pin
T-Arm
Socket