SECTION 10—WHEELS
Part No 1127114
105
Compass™XE
and Allegro®
FIGURE 10.4
Adjusting the Quad-Release Axle - Removing the Play From the Rear Wheels
Removing the Play From the Rear Wheels
NOTE:
For
this
procedure,
refer
to
FIGURE 10.4.
NOTE:
The
adjusting
nut
on
the
quick
‐
release
axles
originally
performed
this
function.
1. With
the
rear
wheel
and
quad
‐
release
axle
still
mounted
onto
the
wheelchair,
make
the
following
adjustment:
A. Tighten
the
length
adjusting
screw
until
there
is
no
in
and
out
movement
of
the
quad
‐
release
axle
and
rear
wheel.
Replacing Handrim
WARNING
Tire MUST be deflated before any disassembly procedures are performed.
NOTE:
For
this
procedure,
refer
to
FIGURE 10.5
on
page
106.
Spoke Rear Wheels
1. Remove
the
rear
wheel
from
the
wheelchair.
Refer
to
Removing/Installing
Rear
Wheels
on
page 101.
2. Remove
all
air
from
the
bar
by
pressing
down
on
the
pin
in
the
center
of
the
valve
stem.
3. While
carefully
holding
the
tire,
bar
and
rim
strip
to
one
side,
hold
the
mounting
screws
and
remove
the
locknuts
that
secure
the
handrim
to
the
rear
wheel.
4. Remove
the
existing
handrim.
5. Install
the
new
handrim
by
reversing
STEPS
1
‐
4.
Locking Pins
In and/or Out
Locking
Screw
Quad-Release Handle
Length Adjustment
Screw
Axle Mounting
Plate