Thrii
Installation
Page
4
of
23
All information including dimensions, changes in design and material are subject
to manufacturer’s change without formal notice and without obligation. Intersan
assumes no responsibility for use of superseded or voided information. Verify all
rough-in information before installation. It is the responsibility of the installer to
conform with local and national codes.
Intersan Manufacturing Company
1748 West Fillmore St., Phoenix, AZ 85007
Phone: 800-999-3101 Fax: 602-254-1776
intersanUS.com
THRII-inst-Rev1
by
4.
Technical Specification
Weight
Item
Fascia
Engine Support
frame, etc. Full
soap container
Total
Solid surface
33.73 lbs.
15.43 lbs.
9.92 lbs.
5.73 lbs.
64.81 lbs.
Stainless Steel
17 lbs.
15.43 lbs.
9.92 lbs
5.73 lbs.
48.06 lbs.
Dimensions
Width
Height
Depth
± 17-3/4”
± 31-1/4”
± 12-1/4”
± 17-3/4”
± 34-1/4”
± 12-1/4”
(9-7/8” behind the panel on all models)
Water Supply
Minimum pressure
Maximum rating
Inlet connection size
Dynamic
14.5 psi / 100 kPa
145 psi / 1000 kPa
½” NPT
Electrical Power requirement
120V AC, 60Hz, 20 Amp
Enclosure IP Rating
IPX4
Regulatory compliance
Complies with:
IAPMO Green Plumbing and
Mechanical Code Supplement
Cal Green
LEED
National Green Building Standard™
Natural Resources Canada R-2000
Standard
Green Building Assessment Protocol
for Commercial Buildings
Solid Surface and Plumbing Code
Compliance
Uniform Plumbing Code (UPC®)
International Plumbing Code (IPC®)
IGC 127-2009
Water heater
Water temperature range
Factory set @ 100°F
*Based on 54°F supply
temperature, 43.5 psi
dynamic pressure & 120V
supply.
86°F to 113°F Flow rate of
0.4 gpm*
Water Resistivity
Water resistivity must not be less than 1300
Ωcm (511.81Ωin) (refer EN603355-2)
