Thrii
Installation
Page
21
of
23
All information including dimensions, changes in design and material are subject
to manufacturer’s change without formal notice and without obligation. Intersan
assumes no responsibility for use of superseded or voided information. Verify all
rough-in information before installation. It is the responsibility of the installer to
conform with local and national codes.
Intersan Manufacturing Company
1748 West Fillmore St., Phoenix, AZ 85007
Phone: 800-999-3101 Fax: 602-254-1776
intersanUS.com
THRII-inst-Rev1
by
b.
The reset can be done when the soap prime push button is activated but this option has to be enabled by setting
menu item F148 to 1. Refer to section 7.2 for “Advanced Adjustments”.
7.1.2
Dryer Operation
There are 3 dryer speed settings. The control to adjust the speed is located at the rear of the unit. To change the
speed the unit must be powered up (The fan does not need to be operating). On the LCD Control there is a small push
button labelled ‘Fan Speed’. Press and hold this button to select the desired setting, this is confirmed by an
illuminated LED and a five second fan cycle.
Note: Lowering the fan speed will take longer to dry the hands.
7.2
Advanced adjustment
The unit is supplied with factory settings as shown in table below. Further adjustments can be made to the
configuration of the water, soap and air operations & to the cycle sequence.
Incorrect alterations to the default hand wash settings may result in malfunctions or possible unit damage. If in
any doubt contact Intersan
for advice & information.
1.
To change the settings you will need to enter the programming mode, press and hold ‘MENU’, ‘SELECT’ and
‘ENTER’ buttons simultaneously for 5 seconds see
Fig. 18.
After this period the display will read ‘F 01’.
2.
With ‘F’ menu item displayed (as shown in the
Fig.19
), momentarily pressing the ‘UP’ and ‘DOWN’ buttons
will move up and down the menu selection.
3.
When the desired menu item is selected, press the ‘ENTER’ button to confirm. The display will show the
current value, flashing, for that menu item.
4.
To adjust the flashing value, press the up or down button as required.
5.
To save the required value, press the ‘ENTER’ button. This action saves the value and switches the display
back to the selected menu item.
