Thrii
Installation
Page
18
of
23
All information including dimensions, changes in design and material are subject
to manufacturer’s change without formal notice and without obligation. Intersan
assumes no responsibility for use of superseded or voided information. Verify all
rough-in information before installation. It is the responsibility of the installer to
conform with local and national codes.
Intersan Manufacturing Company
1748 West Fillmore St., Phoenix, AZ 85007
Phone: 800-999-3101 Fax: 602-254-1776
intersanUS.com
THRII-inst-Rev1
by
5.
Upon initial power-up the Thrii automatically runs through a 15 second water calibration cycle. This is repeated every
time the mains power supply is interrupted. This will also activate the clock on the LCD.
6.
Reopen the fascia using the key provided.
Important! A range of compatible liquid soaps & specifications are available from Intersan.
7.
To install the soap container, place the soap container into its stowage position, to the right of the engine unit (
figure
a)
, ensuring the cap is outer most.
8.
Unscrew the cap from the soap container (
figure b)
and replace with the push-fit cap pre-connected to the soap tube
(
figure c)
pushing fully into place ensuring no leaks.
9.
Press the soap prime switch, (located at the rear of the engine unit in the window aperture to the left of the mains
connector, until soap is consistently dispensed into the bowl.
If only rear access is required lock the fascia into the closed position using the front screw fixing and secure
using the fixings provided.
10.
When ready for use, a green light will emit from the dispensing unit into the wash bowl. Once hands are placed under
the dispensing unit this light will turn to blue and will activate the wash cycle. The light then changes to red when the
hand dryer is operating.
Check the wash & dry cycles operates correctly as per the list of checks below and repeat the cycle at least five times.
Soap dispenses
Water dispenses & water is warm (Note that water dispenses whilst hand sensor detects the presence of hands in
the bowl, the water will stop when the sensor fails to detect any hands after a period of 2 seconds.
Hand dryer operates (Note that the dryer operates whilst the hand sensor detects the presence of hands in the
bowl, the dryer will stop when the sensor fails to detect any hands after a period of 2 seconds.
