Interroll Module belt conveyor SH 1100
Maintenance and repair
58
Version 1.0 (06/2022) en
Translation of original operating instructions
Replacing the module
conveyor (center drive)
1
2
4
3
4
5
2
1
Module conveyor path for center drive
1
Front idler axle
4
Idler pulley
2
Return axle
5
Drum motor
3
Module conveyor
Requirement:
R
The module is shut down.
4
Remove contact guard and cover plates at drive station,
see "Removing/installing contact
guard and covers at center drive station", page 53
.
4
Remove the end plates,
see "Removing/installing front side idler axle end plate", page 56
.
4
Remove the return wheel cover,
see "Removing/installing cover plates at return axles",
.
4
Drive the connecting rod out of the module conveyor with a hammer and mandrel.
4
Thread out the old module conveyor and properly dispose of it.
4
Guide new module conveyor (3) around sliding guides, front idler axles (1) and drum motor
(5) and thread it in above the return axles(2) and idler pulleys (4).
4
Combine the module conveyor without sagging and drive in the connecting rod using a
hammer and mandrel.
4
Install the contact guard and cover plates at the drive station in reverse order.
4
Install the end plates and return axle cover in reverse order.
