International HS 2.8L, Service Manual

Page: 74 / 130

International HS 2.8L Pistons and Connecting Rods
7 3
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
3. Assembly ring spring in piston 3rd groove
and next ring, with ends in opposite position
from spring ends. Install 2nd and 1st rings
with TOP mark or inner chamfer upwards.
Note that 2nd and 1st grooves rings have
different thickness.
4. Clearances between rings ends must not be
aligned in the same direction of piston pin or
skirt. Position rings according the illustration.
5. Assembly new shells on connecting rod
body, correctly positioning locks.
Installation
1. Set engine block in horizontal position.
Lubricate grooves, inside liners, connecting
rod shells and crankshaft crankpin.
2. When assembling piston, make sure that the
arrow is aiming the engine front side. Install
connecting rod with the tool nr. 8130646,
avoiding scratching the liner.
3. Assembly piston in cylinder, using tool nr.
8130647 and a rod of wood to push the
piston.
4. In turbocharged engines, there is one injector
of lubricant oil for each engine cylinder.
During piston assembly in the cylinder, check
the position of the connecting rod in relation
to the injector, avoiding breaking its injection
pipe.
5. The positioning of the oil injector inside the
engine block is checked with the engine
viewed from the top, without cylinder head.