International HS 2.8L, Service Manual

Page: 66 / 130

International HS 2.8L Engine Block
6 5
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
18. Remove accessories support.
19. Remove rear seal and crankshaft.
20. Remove pistons and connecting rods.
Cleaning and inspection
1. Remove oil gallery rear plug.
2. Remove all water gallery plugs and lubricant
oil filter support.
3. Flush block with water at 80°C (176 °F)
under pressure and a chemical grease
remover. Keep block in an immersion bathing
with a solution of the same type for 12 hours
and dry with compressed air.
4. Clean block galleries, flush again with hot
water under pressure and dry with
compressed air. Make sure that the
passages of water and lubricant oil are
unobstructed.
5. Check for cracks or other damages in the
block. Measure cylinders bore, see
CYLINDER.
6. Assembly water gallery plugs applying Loctite
601. Fix aluminum washer and oil lubricating
rear plug applying Loctite 271.
CAMSHAFT BUSHING AND BEARING
Removal
1. Quit camshaft bearings bushing using tool nr.
8130635 and tool nr. 8130636.