International HS 2.8L, Service Manual

Page: 40 / 130

International HS 2.8L Fuel System
3 9
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
5. Turn crankshaft to the valves of the cylinder
nr. 4 to be swinging (1st cylinder piston at
TDC in compression stroke).
6. Continue turning crankshaft clockwise until fit
the center pin.
7. Install the tool pin nr. 8130633 in the fuel
injection pump pulley.
8. If, with the pin of timing nr. 8130632
introduced in the flywheel, the timing tool pin
nr. 8130633 can not be easily introduced in
the fuel injection pump, proceed as following:
a. Make sure that the timing pin of the
flywheel are not introduced in the hole.
b. Turn slightly crankshaft, enough to allow
the timing pin fitting in the pump.
c. Remove retention plate and lock pump.
d. Loosen the three fixation bolts of the
pump gear.
e. Turn crankshaft to TDC until cylinder nr.
1 in compression.
f. Check if the timing pin can be easily
introduced in the pump and in the
flywheel.
g. Tighten fixation bolts of pump gear
according to specification.
h. Unlock pump, install retention plate and
tighten screw.
i. Remove pump and flywheel timing pins.
9. Using an adequate anti-adherent compound,
install the flywheel housing plug and tighten it
according to specification.
10. Install inspection cover with gasket in the
timing housing cover and tighten bolts
according to specification.
11. Reinstall nozzle-holders pipes.