a. Insert the CD, open the V -ILT1700 folder on the CD and double click ILT1700Run -Time folder.
b. Select the setup.exe file and double click the file to start the installation process.
c. Continue to go through each screen and select Next until the installation is complete. (You will need to
accept the terms and conditions).
d. Click on Finish, and restart your computer.
e. The Virtual ILT1700 -USB program will be installed in the C:\Program Files\ILT1700 directory. The
ILT1700.exe can be opened using Start menu\All Programs\ILT1700.
D. TAKING MEASUREMENTS
Before you begin, cover the detector connected to the ILT1700 with the black cap or an opaque
object for about 10 seconds, (or disconnect the sensor from the back of the ILT1700 ) and press the zero
button on the front of the ILT1700. Wait until the zero light shuts off and the DC light illuminates.
With the ILT1700 program up on your monitor, look for the drop down box in the lower
left corner and select the assigned COM port. If you are not sure which COM port you are using, this
information can be found in the Device Manager of your computer. Use Control
Panel\System\Hardware\Device Manager\Ports in the Start Menu for information. The default COM port
is set at COM4.
There are three buttons at the top left of the Screen.
= Run,
= run continuously,
= abort (For
this application we only use the RUN button, do not use run continuously or abort)
To start the program click the Run Arrow button
and it will change to a d arkened arrow
. Read
and follow the instructions on the pop -up window, then click OK. (The check box
can be used
to disable this pop-up message).
The Start button will flash yellow, Click on the start button to initiate data acquisition.
If you need to do a software zero, cover the detector connected to the ILT1700 with the black cap and
press the Zero button
. The LED indicator will turn green until complete and the Zero Level
indicator should read
. Assure the meter was already zero-ed prior to using the program.
The red LED of the Signal/DC indicator
should be blinking indicating that the program
is acquiring data and the graph should show readings that match the display on the ILT1700.
代理美国International Light辐照计http://www.testeb.com/yiqi/ilt/zhaoduji.html 深圳市格信达科技 电话18823303057 QQ：2104028976
