Intermec Trakker Antares 2475, User Manual

Page: 85 / 104

Chapter 4— Troubleshooting and Maintaining the Terminal
Trakker Antares 2475 Vehicle-Mount Terminal User’s Manual 71
3 Scan the Reset Firmware label to restart the firmware and application.
Reset Firmware
*-.*
*-.*
If the terminal or application still will not respond, reset the terminal. For
help, continue with the next section.
Resetting the Terminal
If you performed the steps in “Troubleshooting a Locked Up Application”
and the terminal or application is locked up and the terminal will not
respond to the Reset Firmware command, follow the steps in this section
to reset the terminal.
To reset the terminal
• Scan the Boot Terminal label to reboot the terminal.
Boot Terminal
*-.1*
*-.1*
If the terminal will not scan, you can perform a destructive reset (cold boot
the terminal). A destructive reset can have unpredictable results.
To perform a destructive reset
1
If possible, press
œ
to turn off the terminal.
2 Press and hold the
œ
key for approximately 12 seconds. The Good
Read status light blinks once and the terminal turns off.
3 Press
œ
to turn on the terminal. The Boot Menu appears.
4
Press
1
to boot the terminal. After the terminal boots, your
application appears.
5 Set the time and date. For help using the TRAKKER Antares 2400
Menu System, see “Configuring the Terminal With the Menu System”
on page 27.
If the terminal will not boot or reset, contact your local Intermec service
representative for help.