32
Intermec EasyCoder 201 II – Technical Manual
EasyCoder 201 IIE (Enhanced) is intended for applications, where
the printer not only can be controlled from a host computer, but also
to some extent from the its built-in membrane keyboard.
To allow full flexibility, each key is programmable and the key-
board can be remapped.
Keys, that are not used, can be disabled and the beep signal, that
usually acknowledges a key being activated, can be turned off.
Please refer to the Intermec Fingerprint Reference Manual, state-
ments
KEY ON/OFF
,
ON KEY GOSUB
and
KEY BEEP
for further
information.
EasyCoder 201 IIE can be set up by means of setup files and setup
strings, but is also provided with a “Setup Mode” which allows it
to be set up in regard of all parameters by means of its own keyboard.
The Setup Mode can be accessed via the Intermec Shell program,
by the issuing of the Intermec Fingerprint statement
SETUP
, or by
pressing the < Setup > key in the Intermec Fingerprint's immedi-
ate mode.
EasyCoder 201 IISA (Stand-Alone) printers are fitted with a dedi-
cated application program, which allows the operator to control the
printer from its own keyboard without any computer being con-
nected. The Stand-Alone program, which is described in a separate
manual, provides access to the Setup Mode, which is exactly the
same as for EasyCoder 201 IIE, with the exception of some key
designations.
General Information
SETTING UP EASYCODER 201 IIE & 201 IISA
