Intermec DCS 300, User Manual, Page: 97 / 452

Connecting to the Intermec RF Network
4-3
4
This chapter explains how to connect the DCS 300 to the 900 MHz RF network using
RF cards and 9181 Base Radio Units (BRUs). It also explains how to connect the
DCS 300 to the UDP Plus network using access points, JANUS devices, and Trakker
Antares terminals. It also explains how to connect the DCS 300 to the WTP network
using access points and WTP devices.
Chapter Checklist
Done? Task Page
Y
Connect the DCS 300 to your Ethernet or token ring network. 3-4
Y
Connect the DCS 300 to your Intermec 900 MHz RF network. 4-4
Y
Configure the RF cards in the DCS 300 to communicate with the
BRUs. 4-6
Y
Set the time parameters for the 900 MHz RF network. 4-10
Y
Configure your UDP Plus network. 4-18
Y
Set the time parameters for the UDP Plus network. 4-21
Y
Configure your WTP network. 4-31
Y
Edit the JANUS 900 MHz device parameters. 4-15
Y
Edit the UDP Plus device parameters. 4-27
Y
Edit the WTP device parameters. 4-38
If you already understand and have performed these tasks, connect the DCS 300 to your
CrossBar network or host environment as described in these chapters:
•
Chapter 5, “Connecting to the 9180 and the Intermec CrossBar Network”
•
Chapter 6, “Running Data Collection Browser”
•
Chapter 7, “Running Terminal Emulation”
•
Chapter 8, “Running Peer-to-Peer Applications”
•
Chapter 9, “Running Terminal Sessions”
Note: The 900 MHz card is not available on the 0300D. The 0300D can only connect to
a network through serial or Ethernet connections.