Interlogix UltraView PTZ, Installation Manual

Page: 64 / 68

UltraView PTZ
Installation Manual 54
Table 15. Panasonic commands supported
Command Note
Set preset out of GUI See Panasonic keypad documentation
Go to preset XX See Panasonic keypad documentation
Enter/exit into menu mode Press the button of “CAMERA SETUP/SETUP/PROGRAM” for 2
seconds while the “SHIFT” indicator is lit (or not)
Autopan press the button of “AUTO”
Run preset tour 1 “Press the numeric button 3 then press AUTO or [7]+[2]+[CAM
FUNCTION]”
Run preset tour 2 “Press the numeric button 2 then press AUTO or [7]+[3]+[CAM
FUNCTION]”
Run learn tour 1 “CAMERA SETUP + PATROL PLAY or [1]+[6]+[5]+[CAM FUNCTION]”
Run learn tour 2 [1]+[9]+[4]+[CAM FUNCTION]
Run learn tour 3 [1]+[9]+[5]+[CAM FUNCTION]
Run learn tour 4 [1]+[9]+[6]+[CAM FUNCTION]
Program learn tour 1 “CAMERA SETUP + PATROL LEARN or [1]+[6]+[7]+[CAM
FUNCTION]”
Program learn tour 2 [1]+[9]+[7]+[CAM FUNCTION]
Program learn tour 3 [1]+[9]+[8]+[CAM FUNCTION]
Program learn tour 4 [1]+[9]+[9]+[CAM FUNCTION]
Home position HOME/ESC
Flip [1]+[7]+[8]+[CAM FUNCTION]
Day/night toggle Press the AUTO/B/W/PATROL STOP button while the SHIFT indicator
is lit
Table 16. Bosch RS-232 commands supported
Command Note
Set preset out of GUI SET-XX-ENTER
Go to preset XX SHOT-XX-ENTER
Enter into menu mode ON-46-ENTER
Pan flip (180), Bosch dome does 360 ON-1-ENTER
Left pan limit SET-62-ENTER
Right pan limit SET-63-ENTER
Autopan ON-2-ENTER
Run preset tour 1 ON-8-ENTER
Run preset tour 2 ON-7-ENTER
Run learn tour 1 ON-50-ENTER
Run learn tour 2 ON-52-ENTER
Program learn tour 1 ON-100-ENTER