Interlogix UltraView PTZ, Installation Manual

Page: 20 / 68

UltraView PTZ
Installation Manual 10
Backward compatibility with CyberDome I housings
The UltraView PTZ is compatible with CyberDome I housings, but there are some exceptions. Although the
onscreen display (OSD) interface, including menus, will show the UltraView PTZ design, not all of the
UltraView PTZ features are supported on CyberDome I housings. The following features are not available:
• Site-tied memory
• Internal alarms
• Internal relays
• Internal wiring terminal blocks
• Advanced heater and fan system
• Lift and gain functionality.
• Up-the-coax (UTC) protocol support
Also, if you install an UltraView PTZ in an older CyberDome I housing, you must install a fan assembly on the
tilt arm of the PTZ. (See
Fan installation on page 19 for instructions.) You may use the fan from your
CyberDome I PTZ, or call Customer Service (see Contacting us on page 38) to order a new one (part number
1046540).
Various mounting and housing styles
There are three basic mounting styles: pendant, wall, and flush. A pendant-mount lowers a dome from a
ceiling, a wall-mount extends a dome from a wall, and a flush-mount raises a dome’s dome even with a ceiling.
See
Figure 5 . This document provides the instructions for all mounting styles.
Figure 5. Basic mounting styles
There are four basic housing styles: flush-mount, plastic pendant-mount, cast aluminum pendant-mount, and
heavy-duty (
Figure 6 ). Installation is generally the same for all housing styles. There are some differences,
such as how the dome rings attach to the housings ( Figure 28 on page 33). Where differences exist, the
instructions will specify.
WARNING: UltraView PTZ has different power requirements to those of the CyberDome I. Consequently new
cabling may be required when replacing CyberDomes with UltraView PTZ domes.. Ensure that the
correct power cable is used. See
Table 4 on page 6 for further information.
Pendant-mount Wall-mount Flush-mount