Interlogix UltraView PTZ, Installation Manual

Page: 57 / 68

47
GEA-114 T-bar ceiling support kit
The T-bar support kit is used to install a flush-mount dome into a paneled T-bar ceiling ( Figure 37 ). T-bar
ceilings consist of a grid of metal T-bars that support removable panels. The kit distributes the weight of the
dome between the T-bars of the ceiling, instead of resting it on a panel.
Product contents
• 1 ceiling ring
• 2 angle brackets
• mounting hardware (six 6-32 x 2-in. (51 mm) flathead screws)
• installation instructions
Figure 37.Parts of a supported T-bar ceiling
Installing the T-bar ceiling support kit
One side of the ceiling ring is flat; the other side has two press nuts. Orient the ceiling ring as directed in the
instructions.
To install a T-bar ceiling support kit, see the corresponding figures and do the following:
1. Remove the removable ceiling panel where the flush-mount housing will be installed.
2. Center the angle brackets and ceiling ring (flat side to the brackets) on the removable ceiling panel
aligning their center mounting holes ( Figure 38 ).
CAUTION: For all installations, heed these cautions:
• Complete all installation steps before supplying power to the dome.
• To ensure proper operation of a PTZ unit, install the mount level.
• For safety, the mounting surface, hardware, and procedure used for securing the dome must
support the weight of the dome, mount (if used), cables, and any structural or environmental
vibration according to local codes. See
Table 1 on page 4.
Angle brackets (provided with kit)
Removable ceiling panel
Ceiling T-bars
Ceiling ring (provided with kit)