Intergraph Zx10 Ultra-Tower, System Manual

Page: 29 / 100

17
Configuring System Audio
The system has a PCI audio controller integrated on the system board. The required driver
software was installed before shipment.
If you connect a microphone and speakers to their ports on the I/O panel, you can use the audio
mixer software to control the speaker volume, the microphone input level, and other system audio
features. The audio mixer is available from the operating system’s taskbar tray. You can also
configure audio levels by using the operating system’s Volume Control and audio control
programs. The Volume Control is available from the operating system’s taskbar tray.
For more information on using the audio control programs, see the operating system
documentation and Help. For more information on the audio controller, see the System Board
Manual.
Configuring Networking
The system has a 10 Mbit/100 Mbit Ethernet network controller integrated on the system board.
The network controller features remote management and Wake-On-LAN capabilities. The
required driver software was installed before shipment.
Before you configure networking, ensure that the system is connected to the network. Then go to
Network in the operating system’s Control Panel to configure networking. Follow the instructions
provided to set up the system to connect to and communicate over a network. Be sure to set up the
appropriate network protocols, such as TCP/IP, for the network to which you are connecting the
system.
After installing network protocols, you may need to reinstall the appropriate operating system
Service Pack software as recommended by Microsoft. See the Service Pack documentation
delivered with the system for more information.
See the operating system documentation and Help for more information on setting up the operating
system to use a network. For more information on the network controller, see the System Board
Manual.