Intergraph TDZ-300, Setup And Maintenance Manual, Page: 80 / 136

66 Chapter 5 - Upgrading the System
5. Click on the A:, C: parameter to change the boot sequence; then, press
ENTER
.
6. Select the Exit and Save option to exit the AMIBIOS Setup program.
7. Insert an MS-DOS-bootable diskette into the floppy disk drive and
restart the system.
For more information about the AMIBIOS Setup program, refer to Chapter
7, “Using AMIBIOS Setup.”
ISA Boards with a Configuration File
Some ISA boards are shipped with a diskette containing a configuration file.
The configuration file can be loaded to the system so that the BIOS reads
this file to assign resources during startup. If you install ISA boards that are
shipped with a configuration diskette, follow this procedure:
Note: If a configuration diskette is not delivered with the option board,
refer to “ISA Boards without a Configuration File” in this chapter.
➤
To define ISA boards with a configuration file:
1. Shut down and power off the system.
2. Insert the SYSUTIL diskette into the floppy diskette slot of the combo
drive; then, restart the system.
3. When the MS-DOS Startup menu displays, select the System
Configuration Utility option.
4. Use the arrow keys or the mouse to select Step 2 from the SCU Main
Menu. Then press
INSERT
to add a board that was not detected or has
not been installed yet.
A prompt displays, requesting you to copy the configuration files
needed to configure the system. The configuration file is on a diskette
provided by the ISA board manufacturer.
5. Press
ENTER
to accept A:\ as the path to the configuration file.