48 Chapter 4 - Maintaining the System
CAUTION
Do not connect the MIDI or game cable to the Ethernet AUI port. This
will short out the local area network on which the system resides.
6.
Connect the system power cables to the P1 through P5 connectors.
The power cable connectors are labeled with the corresponding
system board connector.
7.
Connect the reset, disk activity LED, and power on LED cables to the
system board.
Note:
The orange wire for the disk activity LED cable must connect to pin
1. The white wire for the power on LED cable must connect to pin
1. The orientation of the reset cable wires is not critical.
8.
Install the riser card and the peripheral brace.
9.
Replace the PCI option board support bracket, option boards, and their
external cables.
Note:
If installing ISA boards they must be placed in the same slots from
which they were removed. Also replace the I/O lock bracket for the
ISA boards on side two of the riser card.
10.
Install the combo drive; then, connect the floppy cable and ISA bus
cables to the system board.
11.
Install the auxiliary hard disk drive (or its bracket) and connect the
SCSI cable to the system board.
12.
Connect the external system cables (video, parallel, serial, etc.) to the
external ports.
13.
Close the base unit.
Summary of Contents for TDZ-300
