Interactive Technologies SceneStation, User Manual, Page: 91 / 96

SceneStation Installation and Programming Guide Appendix D: Self Test Mode | 85
Appendix D: Self Test Mode
SceneStation includes a built-in Self Test function that can help diagnose possible issues with the
station’s hardware.
The self test tests the following hardware functions:
• LED Button Indicators
• Pushbutton Switches
• DMX Output
• DMX Input
• Infrared (IR) Remote Receiver
Entering the Self Test Mode
There are two ways to enter the Self Test mode:
• When the station powers up, hold Button 2 down. Continue to hold down this button until
after the startup “rainbow pattern” sequence has finished and the station enters the Self
Test mode. Button 2 is the second-farthest from the IR window.
• The Self Test can be activated at any time using the Programmer’s Remote.
Press EDIT + OPTION + 962 .
Testing LED Indicators
While the Self Test mode is operating, all five buttons will
smoothly cycle through all colors of the rainbow, testing
the Red, Green and Blue components of each LED
simultaneously.
All buttons should display the same color at the same time.
If any of the LEDs in the buttons has a defective color com-
ponent, that button will not properly display the same colors
as the other buttons.
Note: If an active DMX Input source is attached to the
station, the LED Test will not function. See the “Testing DMX Input” section below.
Note: If a button is held (or stuck) down, the LED Test will not behave as expected. See the “Testing
Pushbutton Switches” section below.
GOOD
All LEDs the Same
BAD
Button 4 Has No Red