Interactive Technologies SceneStation, User Manual, Page: 18 / 96

12 | Hardware Configuration SceneStation Installation and Programming Guide
The function of each of the switches are described below:
Left Switch Bank Right Switch Bank
Left Switch Bank
• 1: DMX Pull-Up - Enables a weak pull-up resistor on the DMX Data + line. By default, this
switch should be “ON”. This feature can by turned off if some other DMX source on the
line has its own pull-up resistor installed.
• 2: DMX Pull-Down - Enables a weak pull-down resistor on the DMX Data - line. By default,
this switch should be “ON”. This feature can by turned off if some other DMX source on
the line has its own pull-down resistor installed.
• 3: DMX Terminate - Enables a DMX termination resistor on the DMX port. This should only
be necessary when the SceneStation is at the end of a long line of DMX devices receiving
DMX data from another source. Normally, this is not required and should remain “Off”.
• 4: DMX Output Only - When turned “On”, this switch disables the bidirectional DMX data
port, making SceneStation only able to output DMX. This function can be enabled if a
special circumstance requires that the station ignore DMX input. Normally, this switch
should remain “Off”.
• 5: Reserved - This switch is currently unused. Leave in the “Off” position.
• 6: Reserved - This switch is currently unused. Leave in the “Off” position.
• 7: Reserved - This switch is currently unused. Leave in the “Off” position.
• 8: Reserved - This switch is currently unused. Leave in the “Off” position.
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON