Factory Menu
Metropolix’ Factory menu contains various housekeeping, test, and maintenance features. These
modes are meant for use at (or by) Intellijel, and will likely never be needed in the field.
To access the Factory Menu, highlight the
Version
number in the SETUP menu, then press down
and hold the
MOD
button while pressing the encoder.
These are:
Factory Reset
: With this function highlighted, click the encoder to reset all module settings
back to their Factory default settings.
NOTE: This will overwrite any Global SETUP options you’ve configured, and
erase any custom Shortcuts you’ve memorized. So it should not be used as
an ‘INIT’ Preset (which is the function of the
Init Preset
option), but as a way
to return Metropolix to factory settings.
Test Mode
:
IMPORTANT! Do not use unless instructed by Technical Support. Should
you accidentally enter Test Mode, press the EXIT button to escape.
This selection is used by Intellijel to test LEDs and jacks, and is a
factory-level troubleshooting tool. As such, Intellijel’s technical support
department will provide additional instructions in the unlikely scenario that it’s
deemed necessary.
Calibration
:
This selection calibrates Metropolix’ four variable output jacks (
TRK 1 PITCH
,
TRK 2 PITCH
,
OUT A
, and
OUT B
), plus its three variable input jacks (
X
,
Y
,
and
Z
). Metropolix is calibrated at the factory prior to shipment, so it’s unlikely
you’ll ever need to perform any custom calibration. But if you do, the process
is described in
, later in this manual.
Test EEPROM
:
IMPORTANT! Do not use unless instructed by Technical Support. Should
you accidentally press the Test EEPROM Mode, select “No” if asked to
Test/Erase (or press the EXIT button).
This selection is used by Intellijel to test the EEPROM, and is a factory-level
troubleshooting tool. As such, Intellijel’s technical support department will
provide additional instructions in the unlikely scenario that it’s deemed
necessary.
Metropolix Manual
47
