Intel SR1530HSH - Server System - 0 MB RAM, User Manual

Page: 69 / 178

Intel
®
Server System SR1530SH/SR1530HSH User’s Guide 49
12. SR1530SH: Insert the PCI cooling fan onto the mounting pegs located behind the
optical drive bay. The fan label should face the rear of the system. See letter “A” in
Figure 42.
13. SR1530SH: Connect the PCI cooling fan power cable to the fan connector on the
server board. See letter “B” in Figure 42.
Figure 42. Installing the PCI Cooling Fan (SR1530SH)
14. (Optional) Install the front bezel. For instructions, see “Installing the Front Bezel”
on page 23 .
15. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
16. Plug all peripheral devices and the AC power cable into the server.
Removing a Slimline Optical Drive
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
“Removing the Server
System Cover” on page 24 .
4. If it is installed, remove the bezel. For instructions, see “Removing the Front
Bezel” on page 22 .
5. SR1530SH: Note the orientation of the PCI cooling fan located behind the optical
drive bay, then disconnect the fan cable (see letter “A” in Figure 43 ) and lift the fan
from the mounting pegs (see letter “B” in Figure 43 ).
AF002328
B
A