Intel SR1530HSH - Server System - 0 MB RAM, User Manual

Page: 63 / 178

Intel
®
Server System SR1530SH/SR1530HSH User’s Guide 43
Installing and Removing a Hot-Swap SATA Drive
(SR1530HSH)
You can install up to three hot swappable SATA drives. The HDD0 drive bay is at the left
side of the chassis; the HDD1 drive bay is in the middle of the chassis—underneath the
optional optical drive. The HDD2 drive bay is at the right side of the chassis. You do not
need to install the drives in order; you can install HDD1 before HDD0.
Cautions: If you install less than three drives or devices, the empty drive bays must be occupied by
carriers with baffles to maintain proper system cooling.
Note: The server system does not support all hard drives. See “Server System References” on
page x for an Internet link to a list of supported hardware.
Installing a Hot-Swap SATA Drive (SR1530HSH)
1. If it is installed, remove the front bezel. For instructions, see “Removing the Front
Bezel” .
2. Locate the drive position you want to use. See Figure 34 .
Figure 34. Locating Drive Positions (SR1530HSH)
AF002325
HDD 0
HDD 1
HDD 2