Intel Express 510T, User Manual

Page: 23 / 126

681872.bok : 68187201 13 Mon Apr 20 15:35:05 1998
Installation
Express 510T Switch
13
3 Check that the wire colored brown is connected to the terminal
which is marked with the letter L or colored red.
Power supply to a rack
If the switch is installed in a rack, ensure the rack’s power supply
socket has a ground connection and the rack is connected to a branch
supply or a power supply socket with a ground connection.
To avoid overloading the circuit and damaging the wiring of the pow-
er supply, ensure the power supply to the rack is adequate to cover the
extra power consumed by the switch.
Power-up
Powering-up the switch
Follow the steps to power-up the switch:
1
Press the mains switch (on the rear panel) to off.
2 Push the female end of the power cable into the mains socket (in
the rear panel), and plug the other end into the power supply
outlet.
3
Press the mains switch (on the rear panel) to on.
4 Check that the Power LED (on the front panel) becomes green.
If it is not green, check that the power outlet is working cor-
rectly (switched on). If the power outlet is on and the Power
LED is not green, then there is a fault within the switch and
you must contact your dealer.
5
Verify that a LED is lit for each of the front panel ports to which
a powered-on device is connected.
Start-up procedure
Immediately after power-up, the following should happen during
start-up:
Stage When the STATUS LED... Then the Switch...
1 Is red Is starting up
2 Turns to steady green Has started successfully
3 Remains red Has not started successfully.
Try to restart it. If the switch
has still not started, contact
your dealer