f.
settings
28
106. cOnfirM speaker cOnnectiOns & settings
In the headunit, turn the Balance control to fade full Left. Start-
ing with a 20Hz tone, play each higher frequency up to about
4kHz. You should hear only the subwoofer first, then at ~50Hz
you’ll transition to the underseat woofer, at ~150Hz to the mid-
range, and the tweeter at ~2.5kHz. You should hear each speaker
on the left, in the correct order. You may get some sound from
the right, but it should be low level. Fade Balance full Right and
repeat the process. When complete, center Balance & Fade.
107. fasten suBwOOfer
Once you’ve completed settings and confirmed everything is oper-
ating correctly, fasten the subwoofer. The CAD image at left has
some transparancy so you can see how the bolts attach (1). Use
the two
#10-24 x 2.5” Socket Head Cap Bolts
and
Black Flat Washers.
Make sure the enclosure is fully seated into the compartment.
Press the bolts through the carpet and into the hole until they
make contact with the bracket. Start the threads by hand!
You only need to snug the bolts down, DO NOT OVERTIGHTEN!
108. suBwOOfer lOgO Badge
Affix the
Rectangular Domed Logo Badge
to the subwoofer grille (3)
as shown.
109. tweeter Badges
Affix the
Oval Domed Logo Badges
in the forward corner of the
tweeter cover grille. The adhesive can be repositioned several
times in the first 10-15 minutes and takes 48 hours to fully set.
110. rOck. and rOll.
Reinstall trim panels, seats, etc, in the reverse order they were
removed.
That’s it! You should be ready to rock and roll. If you aren’t
seriously impressed by the sound, something is wrong. Trust us
on this. It should be clean, clear, and balanced. If it isn’t, revisit
the steps above or reach out to us for support at 646-926-0011 or
email us at [email protected].
verify that each speaker is
playing correctly.
[subwoofer oNLY]
[subwoofer oNLY]
