f.
settings
24
86. MOunt the suBwOOfer in the enclOsure
Connect the
F30.WH.SUB-INT Subwoofer Internal Wiring Harness
to
the Neutrik terminal in the enclosure. Note polarity markings on
the Neutrik terminal! Connect the other end to the subwoofer.
Mount the subwoofer to the enclosure using the eight
#10-24 x 1”
Button Head Cap Screws
and tighten with a 1/8” Hex Insert the
speaker grille over and around the subwoofer gasket.
87. suBwOOfer wiring (neutrik plug)
Select the 3ft long
Subwoofer Wiring Pigtail
from the
Subwoofer
Hardware Kit.
Connect the Neutrik Speak-on terminal to one end
of the subwoofer wire. Slide the blue chuck (1) over the wire, fol-
lowed by the strain-relief bushing (2). Make the positive & nega-
tive connections to the plug as shown, tighten the terminals with
a small Phillips screwdriver. Slide the bushing (2) forward and
tighten the chuck (3) onto the plug (3).
88. aMplifier cOnnectiOns (suBwOOfer Output)
Connect the other end of the subwoofer wire to the ARC amplifier.
The subwoofer output is connected in the “bridged” configuration
on the amp. Connect the subwoofer output wire to the terminals
shown.
You already connected the USW XO connector earlier, right?? Fas-
ten the amp bracket with the nut removed earlier, tighten with a
10mm socket.
89. suBwOOfer suppOrt Bracket
Make sure the sound liner (1) is back in place. Install the
Sub
-
woofer Support Bracket
(2). The upper end (3) mounts on the same
course-threaded stud as the lower end of the
OEM Amp Relo
Bracket
. The bracket has three holes for fit adjustment, start with
the center hole. Fasten with the
Flange Nut
from the
Hardware Kit
The lower end of the
Subwoofer Support Bracket
will be secured
underneath the hole shown at (4) in the next step.
90. suBwOOfer MOunting Bracket
Slide the two
Clip On Nuts
(1) over the holes in the uprights in the
Subwoofer Mounting Bracket
. Slide the clips on over the outer edge.
The holes in the clips should align with the holes in the bracket.
Use the
1/4” Serrated Flange Bolts
and
Nuts
to
fasten the bracket
through the holes (2). Be sure to fasten the
Subwoofer Support
Bracket
underneath the hole on the right.
The lower mounting bracket holes are slotted to allow for side-to-
side adjustment if needed. Start with them centered.
[subwoofer oNLY]
[subwoofer oNLY]
[subwoofer oNLY]
[subwoofer oNLY]
[subwoofer oNLY]
