c.
signal
w
iring
12
26. MOunt usw crOssOver tO aMplifier Bracket
Mount the F30.XO.USW crossover and to the threaded standoffs
on the underside of the F30.AMP.BRACKET using the four
#6-32 x
0.25”L Machine Screws
. Make sure the connector on the crossover
is oriented towards the near end of the amplifier bracket.
27. MOunt arc aMplifier tO Bracket
Attach the ARC amplifier to the F30.AMP.BRACKET using the four
#6 x 3/8” Black Sheet Metal Screws
from the AMP.MS.R kit. Make
sure the speaker and RCA terminals are on the same end as the
USW.XO.USW crossover.
Place the completed assembly in the amplifier well but do not
mount it to the vehicle yet.
28. hardware selectiOn
Locate the F30.WH.PWR “Power Wiring Harness”.
REMOVE THE FUSE FROM THE FUSE HOLDER, IF PRESENT!
29. attach pOsitive terMinal tO BatterY
Locate the terminal attachment point shown. Remove the nut
with a 10mm socket and attach the positive wire terminal to the
battery terminal. (You did remember to remove the fuse in the
last step, right?)
30. rOute pOwer wire
Route the wire behind the trim panel (1), along the back edge of
the trunk, and over to the amplifier location.
