d.
sO
undst
age
16
46. MOunt iass-8s tO adapter plate
Locate the two
IASS-8S Shallow Woofers
and the
F30.USW.HW-KIT
Underseat Woofer Hardware Kit
. Mount each woofer to an Adapter
using eight of the
#10 x 3/4” Black Screws.
47. hardware selectiOn
Locate the two sets of
F30.WH.USW Wiring Pigtails
, the four
#8-32 x
1” Machine Screws
, the four
#8 Nuts
, and the eight
#8 Flat Washers
.
48. iass-8s wiring
Use the
#8-32 x 1” Machine Screws
to connect the inner and outer
wiring pigtails. The washers should be underneath the ring ter-
minals on both sides.
Connect the positive and negative wires to the speaker terminals
as shown.
49. install the iass-8s wOOfers in the usw enclOsure
Use the four
#6 x 1.25” Pan Head Screws
to mount the woofer to
the enclosure (these are the longer, thinner screws with a round-
ed head - don’t confuse them with the cover screws which are a
little thicker and shorter and have a flat head).
50. re-install the usw enclOsure
Re-install the enclosure in the vehicle. It may take a little wig-
gling to get the open end (the side towards the door sill) to slide
into its slot. Make sure all wiring is run clear. Replace the two
nuts removed previously and tighten with a 10mm socket.
Connect the USW plug to the factory connector. Replace the car-
pet.
