d.
sO
undst
age
13
31. lOcate cOMMOn grOund terMinal
Locate the Common Ground point just forward of the amplifier
mounting location, above the drivers-side rear wheel well.
32. attach negative terMinal tO cOMMOn grOund
Use a 10mm socket to remove the nut and attach the ground wire
terminal on top of the common ground terminal.
Route the wire to the back of the amplifier mounting area.
33. aMplifier cOnnectiOns (usw crOssOver)
With the amplifier in place (but still not mounted) so that you can
route the wires as needed, make the following wiring connec-
tions:
•
Connect the 6-pole plug on the Signal Wiring harness (shown)
to the USW Crossover mounted underneath the ARC amplifier
34. aMplifier cOnnectiOns (pOwer & rca’s)
•
Connect Remote Turn-on wire from the Signal Wiring harness
to the ARC amp Remote On
•
Connect Positive & Ground power wires to ARC amp power
terminals
•
Connect Front RCAs from Signal Wiring harness to ARC amp
Front RCA inputs
•
Connect Subwoofer RCAs from Signal Wiring harness to the
ARC Rear RCA inputs
35. aMplifier cOnnectiOns (speaker Outputs)
•
Speaker Outputs from Signal harness to ARC amp. The wires
are labeled, “FL++” is Front Left Positive, “FL--” is Front Left
Negative, etc. There are two wires bundled together for EACH
output connection. Make sure that BOTH wires are securely
connected to the terminal.
