f.
settings
26
96. setup & tuning
YOU MUST DO EACH STEP EXACTLY AS DESCRIBED. IF POSSI-
BLE, HAVE SOMEONE ELSE READ THE INSTRUCTIONS TO YOU
WHILE YOU PERFORM THE STEPS.
97. initial aMp settings (sOundstage OnlY, 2-ch aMp)
Input Level: LOW/RCA IN. (via selector button on amp end)
BX2: OFF
Gain (aka input sensitivity): minimum on all both channels.
Output: FULL
Crossover: N/A (with output set to FULL, the crossover dial has no
effect).
98. initial aMp settings (sOusuB, 4-ch aMp)
Input Level: LOW
Auto Sense: OFF. (4ch amp only)
Gain (aka input sensitivity): minimum on all 4 channels.
Output: Front -> HIGH; Rear -> LOW
Crossover: Front -> 50Hz; Rear -> 65Hz (note: turn dial fully
counter-clockwise to minimum, then turn up to setting).
99. set Bass & treBle tO flat
From the music control section in the headunit, select TONE ->
BASS. Set the bass level to flat (centered dial). Repeat for TREBLE.
These are cricial!
Center the BALANCE and FADER
Select TONE -> VOLUME SETTINGS -> GONG. Set the gong vol-
ume to the lowest level. You can adjust this back up to preference
later.
100. set aux input levels
If you use any device (mp3 player, sat radio receiver, etc) that uses
a headphone out jack as input to the AUX IN, set the volume on
that device to approx. 80-90% of full volume. Adjust the AUX IN
level setting in the headunit to around 60-80% of full volume.
From the music control section in the headunit, select TONE ->
VOLUME SETTINGS -> AUX INPUT LEVEL and set the level.
setup &
tuning
2ch amp oNLY - No sub
4ch amp sousub
