d.
sO
undst
agae
16
49. reMOve arMrest cOver & triM
Remove Armrest Cover (1) by levering up the edges of the trim in
the directions indicated by the arrows.
Remove the trim cover (2) by releasing the two Torx-25 screws at
either end.
50. Midrange/MidwOOfer (Overview)
The Midrange/Midwoofer crossover network (1) installs in the cav-
ity behind the door armrest cover. The wiring harness connects
to the factory midrange connector (blue). The wiring harness is
routed behind the armrest trim and through the hole at the back
of the midrange cover to the factory connector and the midrange
driver. The wire for the woofer continues behind the midrange,
down and through the rubber grommet and on to the back of the
midwoofer.
51. Midrange/MidwOOfer wire harness
The wiring harness for the speaker and crossover connections to
the door speakers has been pre-fabricated. Connector (1) will plug
directly into the factory midrange connector. The 18” branch (3)
connects to the midrange driver. The 36” branch (4) connects to
the woofer. The stripped ends (2) connect to the crossover in the
armrest.
52. rOute & cOnnect wire harness
Route all wires through the opening (1) at the rear of the mid-
range cavity. Connect the blue connector to the factory mid-
range connector. Leave the midrange wire in the midrange
cavity. Continue running the woofer wire behind the midrange
cavity, then out and down to the rubber grommet (2). Using a
utility knife, cut a small slit in the grommet and run the woofer
wire through and into the door cavity. Be certain all wires are
clear of any moving parts or obstructions!
53. crOssOver cOnnectiOns
Connect the stripped wires ends to the crossover board. The
branch from the blue connector connects to the “IN”. The mid-
range branch connects to “M”, and the woofer branch connects to
“W”. Red is + and Black is - for all three.
[NOTE: Xover board shown with foam cover removed for clarity]
