B.
pO
wer
&
gr
Ound
w
iring
8
11. reMOve right cOwl panel
Open the Bonnet (aka the hood!). Remove the black plastic Cowl
covering the battery by releasing nuts (2) and (3) with a 10mm
socket. Remove the cowl.
NOTE: When replacing the cowl, be sure the seal (1) is seated
properly and that the secondary tab of the cowl (4) is inserted into
the plastic channel (5) that attaches to the bottom of the wind-
shield.
12. reMOve thru-wall cOver
Remove the battery.
Locate the thru-wall bushing behind the battery. Using a flat
screwdriver, release the indicated retaining tabs then remove the
plastic thru-wall cover to expose the thru-wall opening.
13. pOwer wire
Locate the red Power Wire in the amp wiring kit. REMOVE THE
FUSE IF INSTALLED IN THE HOLDER! Remove the auxiliary nut
on the battery post with a 19mm socket and attach the ring ter-
minal on the end of the power wire. Cut the end off of the spare
wiring nipple (at arrow) and feed the red Power Wire into the
cabin. From inside the vehicle, locate the wire coming in. Feed
the wire around the fuse box and along the Right Door Sill.
14. grOund wire
Locate the Common Ground point under the Right Door Sill. Re-
move the nut with a 10mm socket. Attach the ring terminal of
the Black Ground Wire to the Common Ground point.
NOTE: On some vehicles the common ground is located a bit
further forward. Enough ground wire is included to reach either
location.
15. signal wiring harness (Overview)
The signal wiring harness contains all wiring for low and high
level signals, remote volume, and remote turn on. Items are:
(1) X9331 T-harness; (2) Remote turn-on wire; (3) Subwoofer
remote volume control; (4) Left Tweeter speaker wire; (5) Right
Tweeter speaker wire; (6) Subwoofer speaker wire; (7) RCA &
Speaker wire connections to ARC Amplifier; (8) Inline labels for
HIFI/HK systems
