f.
settings
21
74. MOunt the speaKer
Connect the wiring harness to the subwoofer terminals. Mount
the speaker with the #10 x 1” Black Pan Head Screws, using the
pre-drilled pilot holes. Tighten the screws in a “star” pattern,
go slowly and take care not to strip them. Make sure the speaker
flange is flush against the enclosure – the gasket on the back of
the speaker flange MUST make an airtight seal.
75. MOunt the flOOr suppOrts (part 1)
The 3 front supports are assembled with one Rubber Stand-off,
one Cup Washer, and one #10 x 1.5” Pan Head Screw. The rear
supports are twice as tall and are assembled with two Stand-offs
(stacked), one Cup Washer, and one 2.5” Pan Head Screw.
NOTE: The Stand-offs may have warped in transit. To get them to
stack cleanly, wrap a few turns of electrical tape around them at
the seam. Remove after installation.
76. MOunt the flOOr suppOrts (part 2)
Mount the Stand-offs in the pre-drilled pilot holes as indicated.
IMPORTANT: Tighten the screws until the metal Washer is re-
cessed below the top of the Rubber Stand-off, providing a soft
surface for the False Floor. If this is not done, the floor will rattle
on the washer/screw-head.
77. install the enclOsure
Place the enclosure back into the boot. Connect the Speak-on
connector. Insert the Rosette Thumbscrews through the Mount-
ing Brackets and screw into the Threaded Inserts.
NOTE: We recommend coating the threads of the Rosette Thumb-
screws with grease to keep them operating smoothly and avoid
corrosion.
78. hOw tO reMOve the false flOOr
The False Floor Panel slides through the hatch opening and rests
on the floor supports. To remove, simply push down on the edge
near the rear seat backs, lift, and remove – clean, simple, easy!
