Integra DTR-50.3, Instruction Manual

Page: 42 / 100

42
En
By using
Activities
in Easy macro mode, you can
sequentially operate Onkyo components via simple
commands from a single-button press. These commands
are user-definable. See “Using Normal Macros”
(
➔
page 78
).
■
My Movie
First, the TV, the Onkyo DVD player, and the AV receiver
are turned on. The input selector is set to “
BD/DVD ”.
Finally the player starts playback.
*1
*1
Depending on the start-up time of your Blu-ray Disc/DVD
player, the AV receiver may not activate this playback
command. In this case, press
1
on the remote controller.
■
My TV
First, the TV, the cable set-top box, and the AV receiver
are turned on. Then the input selector is set to
“
CBL/SAT ”.
■
My Music
The Onkyo CD player and the AV receiver are turned on.
The input selector is set to “
TV/CD ”. Finally, the player
starts playback.
Note
• While the Easy Macro command is being processed, you cannot
use other Activities . If you want to operate other components,
first press
All Off
and use the desired
Activities
.
Turning Off the Components
This button turns off all components activated by the Easy
Macro mode.
First, the related components stop and turn off. Second,
the AV receiver turns off. Finally, the TV turns off (or
enters standby mode).
*1*2
*1 This step doesn’t apply to My Music , with the default
settings.
*2 With some televisions, the power may not be turned off (or
enter standby mode).
Changing the Source Components
You can change the source components activated by the
Easy Macro mode.
Examples:
If you wished to use My Music to start the Onkyo
cassette recorder, you would press and hold down
My Music (about 3 seconds) while holding down TV/CD
until it flashes twice.
Restoring Default
You can restore Activities to the default settings.
This section explains how to record the selected input
source to a component with recording capability.
AV Recording
Audio sources can be recorded to a recorder (e.g., cassette
tape deck, CDR, MD recorder). Video sources can be
recorded to a video recorder (e.g., VCR, DVD recorder).
Using Easy Macros
1
Press Activities ( My Movie , My TV , or
My Music ) to start the Easy macro command.
The default sequences of actions are described below.
To change the related source component, see
“Changing the Source Components” shown later in
this chapter.
1
Press All Off .
1 While holding down Remote Mode for the
playback component you wish to assign, press and
hold down the
Activities to be changed
( My Movie , My TV , or My Music ) (about 3
seconds).
Activities flashes twice, indicating that the change is
complete.
1
While holding down
Home
, press and hold down
All Off
until
All Off
lights (about 3 seconds).
2
Release Home and All Off , and press All Off
again.
All Off flashes twice.
Recording
1
Use the input selector buttons to select the source
that you want to record.
You can watch the source while recording. The AV
receiver’s
Master Volume
control has no effect on
recording.
2
On your recorder, start recording.
3
On the source component, start playback.
If you select another input source during recording,
that input source will be recorded.