MLR 3G 2.0
Functions
10.3
Dial-In
10.3.1
Configuring Dial-In
You can use the MLR 3G 2.0 as dial-in server or incoming PPP server. The dial-in function
allows for computers to connect remotely via modem through the MLR 3G 2.0 to the
network behind the MLR 3G 2.0. Similar to the dial-in with an Internet provider, users will
authenticate themselves via user name and password at the MLR 3G 2.0. To authenticate
the PPP users, the methods PAP or CHAP are available. Successfully authenticated users
can establish a PPP connection to access the network of the MLR 3G 2.0.
Configuration with the web interface
In order to
enable the dial-in server
, select in the menu "Dial-In" on the page
"Dial-In" the radio button "Yes" for "Activate Dial-In".
You can define an
idle time
, after which the dial-in connection is closed as
soon as no data transfer occurs any more. Enter the required time in seconds
into the field "Idle time". If the connection should remain established al-
though there is an idle operation, enter the value "0".
Define the
number of ring tones
after which the MLR 3G 2.0 will answer a call.
Enter the number of ring tones until going off-hook into the entry field "Num-
ber of rings before answer".
To use
PPP authentication based on user names and passwords
, check the
checkbox "Authentication for Dial-In". If you disable this checkbox, any caller
may establish a PPP connection. Enter up to 10 different
combinations of user
name and password
into the fields "User name" and "Password" and use the
respective radio button to specify whether an
authentication via "PAP" or
"CHAP"
is required for this user. The user name must not correspond with the
one of the dial-out connection.
If a
callback after successful authentication
should be possible for the respec-
tive user, check the checkbox "Callback active". If the authentication is re-
quired for a callback, but this checkbox is not checked, no callback will be per-
formed. A usual dial-in is possible for the caller in this case.
As an
option
, you can define the
IP addresses of the end points of the PPP
connection
, if these addresses have already been allocated to one of the net-
works of the {{{PRODUKTBEZEICHNUNG}} or at a remote network. As default,
the IP address of the {{{PRODUKTBEZEICHNUNG}} is 192.168.254.1. The stan-
dard address of the remote terminal is 192.168.254.2.
Save your settings
by clicking "OK".
39
