INSTEON-compatible RemoteLinc User’s Guide
Page 5 of 18
HOW TO SET UP REMOTELINC
Linking RemoteLinc to an INSTEON Device
To control an INSTEON Device using RemoteLinc, follow these steps to link RemoteLinc and the
INSTEON Device together. Refer to your INSTEON Device’s User’s Guide for detailed instructions on
how to properly install it and link it to RemoteLinc. The following will work for the most common
INSTEON Devices.
1. Choose the ON/OFF Button on RemoteLinc that you want to use for controlling your INSTEON
Device. There are 6 ON/OFF Button Pairs, labeled
Channel 1
through
Channel 6
. You can link
multiple INSTEON Devices to a single ON/OFF Button.
2. Set RemoteLinc to Linking Mode by pressing and holding the
ON
side of the
button for 10 seconds until the Status LED begins blinking.
3. Select your INSTEON Device from the list below and follow the linking method for that Device. You
have about 4 minutes to perform this step before RemoteLinc’s Linking Mode times out automatically.
A.
LampLinc
™
V2 Dimmer
– Press and hold the
SET Button
on the side of
LampLinc V2 Dimmer for 3 seconds, then release. To confirm linking,
LampLinc V2 Dimmer will blink its Status LED and also the light that it is
controlling.
B.
ApplianceLinc
™
V2
– Press and hold the
SET Button
on the side of
ApplianceLinc V2 for 3 seconds, then release. To confirm linking,
ApplianceLinc V2 will blink its Status LED.
C.
SwitchLinc
™
V2 Dimmer
– Press and hold SwitchLinc V2 Dimmer’s
Paddle
Top
for 10 seconds, then release. To confirm linking, SwitchLinc V2 Dimmer
will blink the top LED in its LED Bar and also the light that it is wired to.
D.
KeypadLinc
™
V2
– Press and hold the
ON Button
at the top of KeypadLinc V2
for 10 seconds, then release. To confirm linking, KeypadLinc V2 will blink the
light that it is controlling.
E.
Other INSTEON Devices
– See the INSTEON Device’s User’s Guide.
4. When your INSTEON Device is successfully linked, RemoteLinc will beep, and its Status LED will
stop blinking.
5. Test that your INSTEON Device is working as expected by pressing the ON and OFF Buttons that
you linked to.